AGA GC 3 User's Guide download pdf (Page 7)

When the cooker is in use, the temperature control knob (B) (See Fig. 2) should be between 6

and 7, with the indicator on or about the black line in the silver section of the heat indicator (See

Fig. 9). It may be necessary to adjust the temperature control knob slightly to achieve this.

CAUTION: BEFORE LIGHTING: ENSURE KNOB (A) IS IN THE OFF POSITION (SEE FIG. 4).

ALSO ENSURE GAS SUPPLY TO COOKER IS ON, AND THE SERVICE GAS COCK (C) IS

IN THE ON POSITION (SEE FIG. 2), AND THE ELECTRICAL SUPPLY TO THE AGA IS

SWITCHED ON.

LIGHTING PROCEDURE - SEE FIG

. 3 - 8

1. The main burner gas flow is set with the ‘temperature knob’ (B) (See Fig. 3). Position ‘1’ is

the minimum and position ‘7’ is the maximum temperature setting. First ensure knob (B) is

turned fully clockwise to position ‘1’.

2. Turn ‘ON/OFF’ knob (A) slightly anti-clockwise towards the ignition position ( ) until

reaching stop, press down and hold for 5 seconds (gas flows only to the pilot burner) (See

Fig. 5).

3. Continue pressing down knob (A) while turning further anti-clockwise to the PILOT position

(See Fig. 6) (this activates the piezo) continue to hold down for 10 seconds after pilot burner

has been lit. (if the pilot does not light, steps 2 and 3 can be repeated).

4. Upon lighting, release knob and turn further anti-clockwise to the ‘ON’ position (large flame

symbol) (See Fig. 7). Pilot gas flows and mains gas flows according to the temperature

setting (knob B).

5. Turn the temperature knob (B) slightly anti-clockwise to position ‘2’ (LOW FIRE position) (See

Fig. 8A). Leave in the low fire position for at least 30 minutes

NOTE: Low fire may be between positions 1 and 2. Turn knob until small flame is observed

through viewing window (D).

6. After 30 minutes rotate control knob (B) anti-clockwise to between positions 6 and 7 for

normal running (See Fig. 8B).

NOTE: After several hours the temperature of the cooker can be monitored by the heat indicator.

Setting 6 to 7 should bring the indicator to the black line position. It may be necessary to adjust

the control knob slightly (between 6 and 7) to achieve this.

When the cooker is lit from cold, moisture may form on the enamel which should be wiped off to

prevent staining.

IF THE FLAME HAS EXTINGUISHED FOR ANY REASON, WAIT THREE MINUTES

(MINIMUM) BEFORE RE-LIGHTING.

AUTOMATIC CONTROL

TO LIGHT THE BURNER

TO EXTINGUISH THE BURNER

1. Turn ON/OFF knob (A) clockwise until reaching stop (PILOT) position.

2. Press down slightly and continue turning clockwise from pilot position to the OFF position

(See Fig. 4).

NOTE: LPG APPLIANCE ONLY: When the cooker is turned off a noticeably loud pop

will be heard. This is quite normal.

When the burner has cooled sufficiently, pilot lighting procedure may be repeated.

In the event of power failure your appliance will not work. When the power is restored it will

automatically restart.

POWER FAILURE

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

AGA GC 3 User's Guide Page 7

Comments to this Manuals

Related products and manuals for Cookers AGA GC 3