AGA LITTLE WENLOCK Service Manual download pdf (Page 3)

OPERATION INSTRUCTIONS

WARNING: Do not operate the stove with the

appliance door open, or if the glass panel in the

front door has been broken or removed. Ensure

that the door latch is fully locked. Keep the door

spin valve closed at all times when stove is in

operation.

PRECAUTIONS

1. Do not touch any part of the stove while in

operation, except the controls.

2. Children and adults should be alerted to the

hazzards of surface temperatures.

3. Guards may be required to take account of

the special hazzards that exist in nurseries

and other places where there are young

children, aged or infirm persons.

4. Curtains or other combustible material should

not be positioned on/or above the appliance at

a distance less than 38” (965mm).

5. Do not use this appliance if any part has been

under water, immediately call a qualified ser-

vice technician to inspect the appliance and to

replace any part of the gas control or system

which has been under water.

6. Do not store gasoline or other flammable

liquids having flammable vapours near this

stove.

7. Tools must not be used to turn or operate the

valve control knob.

8. Use only in a sufficiently ventilated space.

9. This appliance must be installed in accor-

dance with the rules in force.

10. Read the label and manual provided before

commencing to install or attempting to operate

the stove.

FAILURE TO DO SO MAY RESULT IN

PROPERTY DAMAGE OR PERSONAL

INJURY.

LIGHTING

1. The stove control knob is located at the

bottom righthand side looking from the front.

2. The valve is in the off position when the

control knob symbol “OFF” is at the datum

point and there is no gas to the pilot or main

burner. The knob can only be turned in a

clockwise direction to reach the “OFF”

position. (see Fig.1)

Fig. 1

3. Press the control knob all the way in and

turn anti-clockwise until you hear a clicking

sound.

4. Keep the control knob pressed for 15-30

seconds, and then release . If the pilot fails

to remain lighting repeat this action.

5. With the pilot burner lighting, to establish the

flame hold the control knob in the fully

pressed position with dot pointing towards

ignition. (see Fig.2)

Fig. 2

6. To light the main burner, fully release the

control knob and turn anti-clock-wise to the

required setting. (see Figs. 3&4)

2

High Flame Setting

Fig. 3

1 2 3 4 5 6 7 8 ... 15 16

Comments to this Manuals

No comments