LITTLE WENLOCK GAS STOVEINSTALLATION AND OPERATION INSTRUCTIONSTo ensure safety, satisfaction and reliable service this stove should be installed by
FACTORY-MADE INSULATED CHIMNEY’SFactory-made insulated chimneys must be con-structed and tested to meet the relevant standardsand recommendations give
WARNING: To avoid pipe sealing compoundsfrom entering into the gas train, do not apply seal-ing compound to the first two threads at the tip ofthe gas
4. Place 4 medium coals on the front of the matrix with their corners touching and also one corner of each coal resting on a spar. (see Fig.26)Fig.26
WARNING: Do not operate the stove with theappliance door open, or if the glass panel in thefront door has been broken or removed.Ensure the door latc
Fig.33Fig.34Fig.35Fig.36Fig.37ENAMEL CLEANINGGeneral cleaning must be carried out when thestove is cool.If this stove is finished in a high gloss vitr
14LITTLE WENLOCK GAS EXPLODED VIEW1. Leg2. Front Frame3. Blanking Plate4. Flue Spigot5. Hob6. LH & RH Side Panels7. Back Casting8. Base9. Burner N
TROUBLE SHOOTING GUIDEPROBLEM POSSIBLE CAUSE SOLUTIONPilot will not light No gas Check gas is turned on.Safety interlock preventing Wait 5 minutes &a
TABLE OF CONTENTSPAGE NO.1. Operation Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
OPERATION INSTRUCTIONSWARNING: Do not operate the stove with theappliance door open, or if the glass panel in thefront door has been broken or removed
Fig.47. To turn off the main burner, turn the control knob in a clockwise direction to low flame. (see Fig. 4)Fig. 58. While pressing the control knob
TECHNICAL DATAPressure Setting From ColdNatural Gas Inlet Pressure = 8”/20mbarProduct Identification No.: 0063 AS 5164Appliance Category BIIBSCountry
This appliance has been tested and approvedin accordance with the essential requirementsof Annex 1 in the Gas Appliance Directive(90/396/EEC) as amend
Fig.11Fig.12When installing the stove against acombustible wall leave a 6” spacebetween the back of the stove andthe wall for air circulation.(See Fig
CHIMNEY’S / FLUESIf connecting to a rear exit configuration the hori-zontal run should not exceed 300mm (12”) fromthe stove outlet. (see fig.17)The he
Fig.18Fig.198USE OF EXISTING CHIMNEYS AND FLUES(See Figs. 18, 19 & 20)An existing flue pipe or chimney that has proved tobe satisfactory when used
Comments to this Manuals