AGA GC 3 Service Manual

09/10 EINS 512427PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLING THIS APPLIANCEREMEMBER: when replacing a part on this appliance, use only spare part

10COMMISSIONING (CONTINUED)LIGHTING THE BURNER - FIG. 2.CAUTION: NO SMOKING OR NAKED LIGHTSOpen the outer burner door to expose the gas control combin

9. Check burner pressure as follows:-Repeat instructions 8 on completely cold cooker with the pressure gauge fitted to the burner pressure test point

12For further advice or information contactyour local AGA SpecialistWithAGA’s policy of continuous productimprovement, the Company reserves the right

SECTION PAGEHEALTH & SAFETY 3INSTALLATION 4LOCATION 4TECHNICAL DATA - 3 OVEN AGA (GC3) ONLY 5TECHNICAL DATA - 3 OVEN AGA WITH MODULE (GC3M) 6TECHN

Consumer ProtectionAs responsible manufacturers we take care to make sure that our products are designed andconstructed to meet the required safety st

With specific exceptions, the installing of any type of AGA cooker is subject to the respectivedirections contained in current issue of The Building R

5TECHNICAL DATA - 3 OVEN AGA (GC3) ONLYFIG. 1 DESN 512841 BABCDE FGHJKLMNPWmm987889 851 679 4671035411330756112573 39 3 698 116PLEASE NOTE: SIDE CLEAR

TECHNICAL DATA - 3 OVEN AGA WITH MODULE (GC3M)FIG. 1A - GAS SUPPLY CONNECTIONS (APPROXIMATE POSITIONS)NOTE: 1/4” BSP to 15mm fitting provided.DESN 512

NATURAL G20MAXIMUM HEAT INPUT 5kWThermostat Bypass 100 or 120Main Burner Injector 400Pilot Injector 4212Inlet Pressure 20mbarBurner Pressure 10mbarPRO

The following notes are intended to give general guidance:-The initial length of flue pipe from the appliance flue socket should be vertical for at le

COMMISSIONING9DESN 512431FIG. 2FIG. 3FIG. AFIG. BFIG. CFIG. D(6)(2)(3)(5)(4)(1)