AGA EC3 User's Guide download pdf (Page 16)

Operating Distance

The Handset will only operate in the same room as the appliance and up to a maximum distance

of 4 metres from the appliance. If out of recommended operating range, the handset may show

“OFFLINE”. Move handset back to within the recommended distance and the handset should

correct itself. See note at foot of this page for “Handset to Base Unit Signal Check”.

Cleaning

The Handset should be wiped clean using a soft clean cloth.

Do not use abrasive cleaning products or submerge the Handset in water.

Batteries

The Handset is fitted with four 'AAA' batteries.

Batteries life will depend on usages.

Replace the batteries when the battery symbol on the Handset is down to one bar following the

instructions below.

- Remove the Handset from the backplate.

- Remove the battery cover plate from the rear of the Handset (fig 13)

- Carefully lever out the batteries commencing with the bottom one first pushing and pulling

out on the positive (+) end only (fig14).

- Repeat the procedure to remove the other batteries.

- Always use long life batteries for replacements.

- Replace batteries commencing with the bottom one working to the top (fig 15) Ensure that

the negative (-) end of the batteries is under the location pegs in the housing before

pushing the other end into position.

Handset Failure

In the event of Handset failure, the appliance would still be operational with the last selected

programme. The appliance can also be changed to manual mode if required using the control

knob (see fig 7).

If the Handset is damaged or lost, replacement can be obtained from Aga and re-programmed

to suit your appliance.

Handset to Base Unit Signal Check/Language Selection

Complete the following procedure to check the handset is communicating with the base unit and

to select a language option.

1. Press and hold the oven vent fan button on the control panel in the

Aga until the blue neon

vent fan indicator flashes, then release button.

2. Immediately after neon starts to flash press and hold the + and - buttons together on the

handset until the blue neon goes out completely (handset display will briefly say connect),

then release buttons.

3. If the neon does not extinguish completely, but continue to flash with faint output, then repeat

steps 1 and 2 above.

4. When the connection has been made, the screen will display the language options, use the

+ or - buttons to scroll through the options to the desired lanugage, then press the button

to confirm selection.

5. If the lanugage option needs to be changed at any time then the whole procedure must be

repeated from step 1.

AIMS HANDSET CARE

Fig. 13 Fig. 15Fig. 14

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

AGA EC3 User's Guide Page 16

Comments to this Manuals

Related products and manuals for Small kitchen appliances AGA EC3